You Canucks are crazy... I'll be well south of the arctic circle, so I don't know if I need to go to those extremes! I don't know how you guys can wo...
Here's the law from The Garden State:13:40-8.1A DIGITAL SIGNATURES AND SEALS a) A digital signature and seal shall carry the same weight, authority, ...
Why do you need this exact rod? Just preference? I'm just curious if there's an advantage....
"I remember the corner being right here..." (standing 20-30' away from the buried mon....)
Mark Mayer, post: 399839, member: 424 wrote: 180 seems to be the number. It is unquestionably very fast. Way way faster than the Topcon PS I use, whic...
I like the Geomax / Carlson combo. You can run an SP80 with Carlson, and the Geomax really seems to be just as good as Leica.
The comments touched on it, but shouldn't that person have to be licensed as a surveyor to hold the title of surveyor? I would think that to be a pre...
Save em for when you're really not sure where the heck to set the pin and voila! Pin/cap found!
Jim in AZ, post: 399042, member: 249 wrote: Our engineering dept. would blow a gasket if I produced engineering design topos using paper space!If I wa...
How cheap are they? I use a Geomax receiever (Zenith 25 Pro), but I only have the one. I run it as a network rover. They have a newer model now (35...
Set the traverse first not after the observations.....
I never have lines going right to the border. I always have them stop about 1/4" inside the border on the paper. Maybe it's just a preference thing....
Williwaw, post: 398955, member: 7066 wrote: Seems half the time I need to share one my drawings with another user and all of my symbols and annotatio...
I don't like the idea. I have a lot more going on in model space than what is shown on the sheet. Usually there is line work that extends beyond the...
Do you have to input 'E' for end? Is it suggesting anything in the command prompt?
rfc, post: 398502, member: 8882 wrote: Suppose the property line is "the center of the brook"?If you plotted the location of that daily, as the water ...
MightyMoe, post: 398477, member: 700 wrote: I would not localize, i would occupy their control and use it as its stated, if that doesnt work then i wo...
Dan Dunn, post: 398448, member: 911 wrote: New Jersey is a US Survey Foot State Oh I am aware! Wish everyone else was....that's where the error come...
Actually, I just noticed that it specifically states that I will be provided a CAD file to use for layout. That's a first - even though that's often ...
Scotland, post: 398414, member: 559 wrote: Dan~ I wonder if the CAD file was created with a another program? I know I set the values for projection...