:good:

A couple of angular errors can easily give the results that you are seeing.Fire up your CAD and do a quick test. Create points #1 and #2 approx. 2200...

Were you using a manual total station or a robot? Did you take single shots on each cp or were you turning sets?

Is it lithium or nickel metal hydride? My son has been into RC helicopters lately and they're powered by lithium polymer cells that come with a two pa...

TOT monuments are hit or miss. Depending on the project I sometimes find rebar set a few tenths off the marked corner of the monument, other times on...

If it is like the 500's & 800's; the worst part is trying to get the spring loaded pulley that keeps the belt under tension back where it belongs....

That was one of the big reasons I decided against a lease when I bought my robot. The thought of paying full sales tax on the front end and then again...

You mention turning off com 4.....is that on the windows or ranger side? I used WinXP with LDD2i and a Husky FS2 for a decade. As I upgraded to new m...

Glad to hear you're okay.I've hit my shin hard enough to have to sit down for a few minutes but never needed stitches. 8" leather boots, heavy canvas...

Go to the printer properties for the plotter under Windows and see if there's a tab for "paper standards" or similar. If so, make sure the arch sizes ...

No, they're straight internal memory with a backup battery, both soldered to the board.

The software disks for these were tied to the serial number of the DC. To my knowledge there's no way to load the disks for one DC onto another and ge...

I call it looking for squirrels. If there aren't any cars or other moving shiny distractions that might have confused it, I change the radio channel....

I just dealt with this over the weekend with Carlson Civil on Intellicad 7.1. Here's what worked for me. I went to "printer properties" for my Design...

Poor assumption on my part. For what it's worth, both TopSurv8 and SurvCE both have hidden point routines that would be suitable for use with a two pr...