Most DC software should have an offset routine that will allow you to locate two points and give an offset along that line to the actual point.

The key is to define your code type as line instead of point. When you use a code defined as "line" TopSurv will automatically show the box where you ...

It's best to edit your profile and check the box that makes your email address "contactable" than to openly post your email address.

Try right clicking on the OLE object once it is inserted and check "send to back" if it's already printing correctly this might make the rest of the s...

I'm running LDD2i and I don't see the issue. I inserted an existing excel sheet into model space using "insert", "OLE Object", "create from file" opt...

I had it happen a while back with LDD2 and Acrobat10. The pdf looked fine on screen but the Oce printer at Kinko's put big black blocks everywhere. Te...

My 2005 Toyota Tundra does.

I no longer use Outlook Express, but I used to get messages where the attachments were shown grayed out and inaccessible. I found a security setting t...

email it to s t e p h e n at ward land surveying dot com (remove all spaces)

Switch to one of your paper space tabs, then toggle the paper/model button at the bottom to model, then open layer manager. Toward the right side of t...

I pulled a couple of firmettes this afternoon with no issues. I used the map to zoom in and get the panel numbers then used the product catalog to gra...

I used to do alot of celltower 1-A and 2-C letters and the AMSL language is pretty much universal. I figured it must have come from above or all lette...

I may have misunderstood, but I believe my dealer told me the reason for the high cost was that the whole radio module had to be replaced instead of j...

There is no cut and dried answer to your question. Building setbacks and their interpretation vary from one jurisdiction to another. I would suggest ...