When the job ended up on my desk, I was told the plat was recorded....Since then I learned it wasn't other than references in deeds. Strangely enough ...
3DP will do what you are asking.....AS long as you draw your files on true Z value. It will also let you hand enter the elevations of the PL nodes.
Lots of good suggestions above.....But have you done a market analysis for the Asheville region. I ran solo there for 5 years and it is a tough market...
I am dealing with the same issues myself. I have found that the RW agents are very nice, but a drive to the district office is usually needed to go th...
Total, I have Carlson 2010 on intellicad at home and Carlson 2017 on Civil 3D at the office......both programs do what you want. I am not sure why y...
Align (al) command will do what you are asking Nate...IT doesn't have the one the fly adjustment.Total- Would a polyline work for you? Then just type ...
In Carlson, create a point group based on you top of curb, flow line, and asphalt shots.....Then under surface there is a draw spot elevations command...
I can only think of two things....In the table defaults did somebody type in a bearing next to the L in the line prefix title or in the auto-annotate ...
You solved the problem, but there is an easier way. Under the edit pulldown is the change dialogue. As long as you know the names of the blocks you ca...
I generally stay away from alphanumeric point numbers, but: Under settings/carlson configure/general setting...Check off Carlson Alphanumeric Hopefull...
If you want just the field codes as your descriptions.....In the field to finish setup boxes make the three lines were you enter description data the ...
It isn't in the new version....I had the same issue. To use the field to finish code tables to sort layers is an all or nothing deal as it was explain...
Brian, This is the link to the Wilmington NC area....You will need to look around a bit to find the area you are in.
I might have used the wrong acronym (might be KML) but I will look tomorrow. It should be in my notes at the office.
Did you look for the other monument on the back of lot 4 South shore drive? If you go to the Army Corp website, they have KMZ files with monuments and...
Adam, Maybe try the cutsheet command under survey. Create a point group of the points you want to check and then import them in the cutsheet spreadsh...
R.J.- I am trying to be vague, so I know the post is hard to read. We never staked an envelope or box for the whole building. We just did a box based ...
