Smallest I go is L60 (60/1000 of an inch), for building dimensions and fence ties. I mostly use L80 and L100 for general labeling. L60 is very clear...

Google must have blocked access to all those 6-year old news stories about NY City banning copy machines, fax machines, and laser printer. It's appar...

Electrostatic printing is used in laser printers, copy machines, and fax machines. I have to question your belief that any city has banned those devi...

my favorite penny-pinching builder..Along those same lines, we had a guy call our office today and left a voice mail. Said he's buying a property and...

One things that wasn't mentioned is that the 360 prism needs external power, and the "brick" prism runs off internal AA batteries. That is a reason w...

I've never seen one that bad in Florida. Mountains do create "geoid undulations" that take an extra dense network of control points to model correctl...

No problem here with an even older version of LDD/Acad. The Add-On package Express Tools was difficult to install, but a computer nerd friend of mine...

Have you tried running it in a DOS shell in Win 7? You'd be surprised at what will still run in Win 7.

If you pull up an NGS datasheet for an older point in your area, does it show the 47 readjustment values in the superseded section?

I don't know much about the S3, but is their a cable available that allows the S3 to connect to a Parani? I.E., a 9-pin serial to S3?

It's a 4"x4"x24" concrete monument. The pic is a little deceiving.

It says in the ad 20 per month. Implies it not a full time job. You'd have to do over 3 per day (240 day work year) to make 40K, minus your expenses...

>Typical successful full time field crew party chiefs make approximately $40,000 per year.By my math, 20 jobs per month X $50 per job (if you provi...

If they are like CTS legs, there is an off-center washer inside that presses against the cylinder to create the friction, and that washer wears out ov...

Is it wearing an old lady shower cap?OK ... I admit, I'm jealous.

This is probably a dumb question, because I know nothing about Civil3D, but is there some reason why you can not open the DC generated DXF linework in...

I agree with you. That's a pain in the butt. I've had the same problem and I've been unable to resolve it. I could not get the points off a TDS/Ran...

I was going to point this out. Most R/R curves are actually 3 curves ... the spiral curve is a transition from a straight segment to a radial curve, ...

Thanks all, I did the field work today, turns out, the house is stranger than I thought and probably wouldn't qualify for a LOMA. The original builde...