Last seen: November 12, 2025 12:24 pm
John Hamilton, post: 400742, member: 640 wrote: I just ordered an external cell modem with wifi, serial, etc from microhard (canadian company). I will...
I still use one 1200 with a AT&T card in a GFU housing and was wondering the same thing. I have an old "Raven" but hate to go back to that config...
I have two seats (subscriptions) of C3D and I keep getting offers from ACAD for 1/2 off rental for 3 years if I trade it in for yearly rentals. Do t...
Building the unit with the lowest horizontal structure beam below the BFE will be a big mistake for you and all involved. The county is required by F...
As usual it depends, if your final product is a printed survey map or electronic map then Carlson with Intellicad is a perfect. If you are part of a ...
This is what I use It will give you the computed difference between the datums, but what is normally needed in my area is the amount of subsidence f...
John Hamilton, post: 368782, member: 640 wrote: You are correct: Planned Obsolence But, using my software converts the dat file back to usable again. ...
This is the way Trimble chooses to do business. The one 4700 I have was the last unit I purchased from Trimble back in 1999 for this very reason. Be...
John Hamilton, post: 366680, member: 640 wrote: Is it possible your base position is not correct? for every 6 meters or so of error at the base, that ...
gschrock, post: 366653, member: 556 wrote: This is puzzler as there is nothing distance dependent in the nature of a caster; it is simply an "exchange...
I've been working with this for several years and but when I upgraded to C3D 2016 I decided to just run Carlson as a separate program using the Intell...
Wait till July use and an inner-tube connected to a case of beer and a 8 foot level rod..
Shawn Billings, post: 343831, member: 6521 wrote: Not one of those statutes mentions ID caps. I'm with Shawn on this, the regulation does not even re...
Locate the lot lines i.e. the centerline of the street as needed then apply the full width of the easement i.e. right of way.
Wendell, post: 323645, member: 1 wrote: I always used Simplex because once plotted, you couldn't really distinguish it from RomanS anyway. Plus it was...
Randy Rain, post: 323642, member: 35 wrote: Robert I hate to even ask but have you checked the textfill sysvar it should be set to 1 Thanks Randy, th...