JBHere is a pic of a Bantam replacement I made due to my stupidity. You can order the parani SD 1000s online and there are a bunch of directions on t...

After several attempts, I found the second week was the hardest but it gets easier from there. Good luck!!!!

I always carry a plumb bob. I use it to drive in nails, make sure I can see between trees on traverse, and mark line. I used a little 12 ouncer tod...

My boundary determinations always hit me in the shower in the morning. Of Course, after spending the previous day looking for the answer in countless...

Great Comment:good:

Thanks Ladd! I should have contacted you first, but I was a lot distracted today. On a personal note, I really like your software and the great supp...

CarlThis happened to me earlier in the year and I wasn't sure what to do. Reading the other DIY post on the board I decided to buy the Piranni units ...

That was what I was told on the phone and apparently he is the Bantam guy.

I did not see an email address, but I might be interested in the hardly used backpack.

Yes i have that setup with ver 4.7.1. in tds settings are Brand = topconModel GPT-8000 remoteSerial port com1baud 9600parity nonethen under instrumen...

Thanks Guys for the advice!!Thanks GuysYesterday I did notice the the battery was not locked into place and it caused the instrument to shut down. I ...

Where is the Like Button?

Check out That Cad Girl's site. You can get 8 hours for $99.00, plus lunch

I believe those are left over if you have the nodes on seperate layers. I have erased points like that and had the node layer off and once that layer...

I like to review the .rw5 prior to processing and when i come across this situation, I will simply toggle the bad shot from SS(side shot) or TR (trave...

When you stake the points in the field, you have to store the set point in the stakeout screen. Then download both the .job and .raw files. Next, go ...