CAD outsourcing>TTT (update)Well, last week I posted about out sourcing drafting work. I had worked myself into a bind and was struggling with som...

I have the gsr 2700 isx so I'm sure it's a little different. I found my range extremely limited, to less than a quarter mile over an open area. I...

April 2105 - Photo of the Month>KarolyI think that is David Karoly holding the notebook 🙂

The Expert

I find it totally feasible. I check in with my control before starting, hit any traverse points during the topo then hit the control again when I'm ...

Not a Monument but...I was working on a contentious little project in the NIMBY neighborhood of Yarmouth on the beach. The non-waterfront owners were...

That will be sweet for those of us on the lower Cape! When it gets running that is...

Working in Truro MASurveying with a Banjo!

A Banjo> Mark Chainhaha, I remember that discussion :-)I survey with a Banjo a lot now, since my dog's name is Banjo.Courtesy of Wendell

Carlson 2014 LABSPOT Command>Plumb BillThanks Bill, I saw something there when I used the Carlson help. I'll check into the F2F a bit more.I used ...

You know what? I couldn't find 3d data or the labspot command. I just use labspot and the table pops up. I hadn't heard of it either and it's a gre...