HP-48 Cable Needed

I'll call a couple friends tomorrow. No promises, but I do know a couple guys that changed data collectors. I'm just not sure they still have the old cords. Will send email if I have any luck. What is the pin configuration for the Topcon your using? I'm assuming you need 9 pin to environmental case holding the 48?

Mark

No environmental case, plugs directly into 48. This is a spare unit I'm firing up, doesn't get used much. I sold another Topcon Total Station a couple yrs ago and I think I left my 48 cable in the case... 😐

Thanks for checking!

David

Ok i'll check. The folks I know are in Washington State. Environmental Cases are a must, with all the rain days. That does lower the odds a bit.

Mark

It has the soft case with a small hole in the end, so the cable plugs directly into the 48.

If they're interested in letting a hard case go with a cable, that's ok too.

I'll see what I can do.

The cable connection to the HP-48 was a weak link in my former Topcon/HP-48 combo. Didn't make a very solid connection.

David,

Call Tech Plus in Memphis, TN. They have at least two sitting on a shelf. I saw them about three months ago.

Hope this helps

Assuming the HP 48 is in a TDS or SMI case the cable should still be available from Hayes or Allen Precision. The

Paul in PA

I have two of them. you are welcome to both if you still need them.
send mailing address to my email, and I will send them to you.

Lee

> I have two of them. you are welcome to both if you still need them.
> send mailing address to my email, and I will send them to you.
>
> Lee

Message sent, THANK YOU!!!

HP-48 Cable Received

Cables received, thanks again! To everyone else, thank you too!