Depending on how you use the software there may be a solution. If you do not need to create linework in the DC, you can switch it from "code" to "note...

Check out this link. I believe your guy is Hatch Mott MacDonald out of Florida.

TopSurv 7.5.2 was the last 7.x release and is available at www.topconuniversity.com. Older versions are available at but they do not go back to versi...

2011-04-28, 21:00

AndyI'm reminded of that same commercial every time I give a homeowner a price for a recorded plat. My price gets repeated back to me in the same tone...

The hunk of metal appears to be a quick disconnect fitting for a hose. I've seen these on fuel tankers, septic pump trucks, etc. - I doubt it has anyt...

Flagstone Hatch - DarrellThank You!!! I was trying to use a gravel hatch in a drawing at state plane coordinates just the other day and it was fragmen...

I download Huskey FS2's & Trimble 4000SSE's to a Windows XP machine via serial cable. A couple of years ago I started having problems with bad con...

Good to know, I'll delete my reply so that he can edit his post. Thanks. Edit: Too late, Wendell replied to my comment. Maybe Wendell can edit Mark's ...

Topcon GTS-3B settings...no manual. - WendellSorry for the confusion. Mark put his email address in the body of his post because I had my email set to...

Sorry, I forgot that I had set mine to be non-contactable. I copied your address and sent the file a few minutes ago. I would suggest that you edit yo...

I have the manual, and I've scanned the section you need. I just can't figure out how to attach it to my post or attach it to an email sent through th...

I know that TDS and TopSurv are both tied to the serial number of the DC. Trimble does not give anything away, so I can't imagine them not having the ...

Another TopSurv Question/Robot QuestionNot under normal circumstances, but after this I may. Based on my field checks today, my suspicions were correc...

Another TopSurv Question/Robot QuestionI still have not found where TopSurv logs the info for translations and rotations, but I've pretty much ruled t...

Thanks JimI have a 303 that has the same design. I never needed to use it, just checked each setup to make sure it had not worked loose. If it gets lo...

I used a 42" 500 for 8 years with only minor maintenance. Key thing to look at in a used unit is the square feet or meters of paper that has been run ...

Had the same thing happen. I had my head down watching the DC as I worked along a curb line. Pushed the button to take a shot and nothing happened. I ...