When you get to the next job you should be able to just "Start Survey" then use the rover and don't reset the base it is already broadcasting correcti...
What i believe really makes the WISCORS ( in conjunction with the WISCCRS) network powerful it the predefined LDPs and the extensive Height Modernizat...
Are you setting a base station up or are these network corrections? Are you moving the base station to different sites or is it staying in the same s...
Under manuals then manual archive.
That ability seems to have gone away in 6.+ so far in 6.- you could assign hard keys on the D.C. To do certain tasks
How close do horizontal cords need to be. If +/- 5' and it's a cardinal direction street and most houses have approximately the same setback could you...
I have never tried without tagging the polyline. There is a option in field to finish that sets a "hard break line" there is also a option in the 3D d...
I don't think they mean if the total tilt is more than 1' I think they mean if the new tilt is more than 1' different than the current tilt
If you are looking for lime or orange class 2 these are nice vests with a back zipper pocket
I can't see how the colmination would be an issue if you are turning sets
Maybe away to line
Could you place a retro target above the shaft and shoot it with an inverted level rod. I am guessing you could use the NL to set the target to insure...
I think that cad girl has a LDD to Carlson migration guide
Try 6.1.1.19 I think that is the newest version. As a side note we ran t41s and now getac t800 and I have only seen 1 resection problem that was fixed...
Ground coordinates vs grid.
They are neither base or rover. not real time kenimatic.
I also remember there was some way to do it through GRIL commands but it was a long time ago I looked into it
All network corrections
I would guess that base_1 was a manually or through ascii entered point and did not have a LLH associated with it and Survey Pro created a paired poin...
How do you have it configured under the "scale factor" tab
