Topcon has specific automated monitoring solutions called Delta Watch. This includes software, total stations and controllers. I believe the monitorin...
We have a Sokkia SDL 30 and we??re happy with it. The onboard software is clunky like previously stated
What I ended up doing with survey pro was turn off the elevation of all points but 1 that was about mid range of what I was staking. Then check other ...
Magnet won??t run Trimble it is a Topcon product. I like it so far some small things I don??t like but nothing insurmountable.
I was a long time Survey Pro user switched to magnet last year. Survey pro uses a 3d resection vs 2d+h. It will weight the V error vs the distance it ...
I have used tapcon masonry screws. Drill the required hole size with a hammer drill and set the screw. I have also used them for control in sidewalks....
We had a ?ÿrobot sitting In the middle of the grade run over with a backhoe. The contractors insurance picked up the replacement value. I am not sure ...
We just upgraded to Hiper HR??s and are very happy with the performance under canopy. We switched from survey pro to magnet software and it took a li...
@chris-bouffard I didn??t realize you were between the wall and the excavation. I thought it was just inside the excavated basement area.
It doesn??t seem that standard trench safety rules are applied to standard 8?? house foundations but maybe 10?? walls would be an issue. Walking a ...
I run a tilt and Collmination every day I haven??t found that I need the image sensor reticle offset as much maybe once a week. Taking to Trimble and...
I find it very telling that the 1? and .5? topcon and Sokkia robots are still servo driven. We have had SRX SX and now IX the SRX and SX while ver...
Did they put under drain in at the edge of undercut?
as long as project coordinates are consistent they are gospel. Projects need to be built off of the system they were designed in. As long as it all is...
Looks a lot like a Spectra Focus 35
I like using tapcon concrete screws. I will drill a hole just slightly larger than the head about 1/4? deep then run the 5/32? tapcon bit through ...
I have no experience with focus or Trimble but do have some with survey pro and Sokkia ix. I hope most days a truck hits my ix. we have constant motor...
Ok think we??re getting a bit off topic I work in a recording state and I record my surveys but I don??t like that a client who is paying for a surv...
Do not get a Quattro card for Carlson if your running Intellicad I don??t know about AutoCad but read the recommended cards for Carlson I have a Quat...