Last seen: June 5, 2026 2:43 pm
Essentially, you're stating that if a title company doesn't do research on a parcel you don't aren't competent to do it yourself; so your survey is la...
I can't remember ever finding an angle iron used as a monument. I have found them as markers for the monument, usually pulling them and listening with...
I measure the dimple
The N1/16th on the east line of Section 5 will be a proration between the E1/4 of Section 5 and the found Closing Corner. The NE corner of Section 5 s...
There are different eras of PLLS plats, it's difficult to decide how to proceed without viewing the plat and knowing the era and seeing the plat. B...
Our field notes went to full books to sheets of field book paper with a DYMO label for the front of the job listing the client, J# and location. Under...
Are there any successful AP cases in the state? How much time have you got? Here is one of the appalling ones (at least from my perspective): Co...
I'm not against this one. It will change AP drastically in the state. Little if any drawbacks that I can see. The only case that I can think o...
If it would stop them from sending along items that pertain to parcels up to a 1/2 mile from the site, I'd be all for it.
A deed that reads the aliquot part excepting the ROW would be the full aliquot part with an easement for the highway. A deed that reads the aliquot pa...
The Strips and Gores rule, but I think it applies to Texas, you might check to see if a similar rule exists in your state. An attorney researched it...
I will say while researching items in their database it asks for a State name then a Township-Range to narrow the location down, and I've seen many of...
Yes, Master Title Plat, there is a bunch of good info on them since the feds have tentacles everywhere I tend to work. Also, I will look at the OG ...
That's my fear, litigation over this, the landowners can't seem to get along.
Geoid18 works well with NGVD29. Any Geoid model works very much same with 29 as with 18 when it's applied to the elevation, not the ellipsoid height. ...