Last seen: March 10, 2026 1:01 pm
@andrew-clark The setting for where to "Store Fixed Only (GPS)" is found under the Equip tab -- Configure: For GNSS receivers that support the "Sure...
Not knowing the specifics of the "older carlson software" (e.g. product and version) you are running, you can explore the following if you happen to b...
If you've applied updated video card drivers, you might also explore the GRAPHICSCONFIG option: Turning off Hardware Acceleration may correct the p...
In addition to what @flyin-solo suggested, see my reply in the CARLSON surface and curves thread. I hope this information helps.
Change "Email" to "phone call" which turns out to be a telemarketer robo-call from whom you want to identify and/or from whose list you want to remove...
Check Carlson knowledgebase article #838 for suggestions/insights: I hope this information helps.
I would encourage careful review of the End User License Agreement (EULA) that accompanied the software (especially Section 4. Restrictions) as it con...
A subtle correction... I hope this information helps.
I have been asked about this numerous times so in the event the following helps, here is a quick run-down of what I would consider are the current "ta...
If you'd care to send me your project data and project settings/processing files, I'll be happy to take a look to see if I can figure out what is thro...
According to the SurvCE Supported Hardware matrix, the last version of SurvCE that had support for the Trimble 5800 was SurvCE 3.x: (set the equipmen...
@dmyhill Presuming you might have meant (emphasis added for clarity): Export C3D exports a drawing...and it is scaled to International Feet, NOT US...
Although I am not a proponent of propagating proprietary custom objects in a DWG file (mainly for future accessibility to that object data in years/de...
I recall hearing from Carlson Technical Support that the toolbar issue is actually an?ÿAutoCAD?ÿbug (presuming that is your CAD engine). You could see...
You might try the suggestions at the article entitled "TOUCHSCREEN NOT RESPONDING OR ACCURATE ON MESA 2" (I believe a cousin unit to the FC-5000) on t...
@lukenz OK, how about this modification then, which uses the length of L2 to govern the length of the result and converts the the text string result ...
@lukenz The following formula would be so much shorter with some intermediate cells serving as surrogates but I believe this formula would handle neg...
Aside from the apparent down-time yesterday, I'm glad the issue wasn't necessarily related to Carlson, GeoMax or you.
What kinds of distance was there between your collector and the robot (possible interference issue)? What version/build of SurvCE 5.x are you using? I...
Your comments and continued support of the products and services offered by Carlson are very thoughtful (and appreciated), Frank! I'm sure Bruce Carls...