CK,I haven't seen this problem. Are your breaklines still affecting the surface? Have you run an audit on the drawing?You really should post this on t...

CK,Post your drawing on the Civil 3D Forum. One thing to check is the Layers in the Figure Styles.Dave

James,"Does anyone actually pay attention to the job requirements when they send their resume in for an advertised position."Yup. I do. I can even rea...

James,"I don't think I've seen a resume from someone out of work in 18 months."I'll send you mine. I've been unemployed for almost 2 years. I live in ...

To shift a window back to home screen, hold Shift + Windows button(between fn and alt), then press either right or left.(Depending on whether your cur...

Squowse,Here's an old thread on that subject:According to North Dakota DOT, you can turn off C&R in the S6:Dave

C'mon, MM!MM,"The engineer disregarded existing control, set up his base one day, collected the topo info, went back to his office, did an OPUS soluti...

Kent, Don't Be Offended, But...Kent,"No, grid bearings expressed as quadrant-bearing angle or as azimuths definitely refer to Grid North. If they refe...

Kent, Don't Be Offended, But..."Bearings of Lines""of Lines" is unnecessary. It's sufficient to just say "Bearings"."Bearings of Lines refer to Grid N...

DavidKris,I like that! We'll have to see if Kent approves.Dave

School me, Kent.Thanks Kent.Dave

School me, Kent."This also shows the power of standard projections. It was immediately obvious that one of the surveys was grossly erroneous as far as...

Andy,Curse removed. Try turning it off, then on again. That should do it.Sorry, couldn't resist.Dave

Awesome! You're having WAAAAY too much fun, Adam!Dave

Norman,I would also like to master the Field-To-Finish stuff in C3D. That PDF from Awood on Steve's thread is good. There's also Sinc's video on the Q...

Richard,Thanks for the link. I think their peg test is not rigorous enough. There should be at least three 90-degree turns instead of just one 180-deg...

Tom,Apologies. Sounds like it works well for you.Dave

Laser Levels work in generally the same way that Autolevels work, only instead of hanging a prism on wires, it's a motorized laser light. If it's in n...

Tom,"You read the back rodman and call him off."But then the back rodman has to wait for you to set up before he can step off the next TP. I really me...