Use The Pulldown Points CommandWell, I tried to recall what I did last time,and I tried entering "e" for the first promptCommand: LPOINTPick point to ...

I created construction phase one points off the line work, previously in the same drawing.They are visible in the drawing.I am moving on to phase 2 an...

I do the same.I use the kickstand for robotics and GPS.If I am going to hike into the woods to locate a corner,I will put the bipod in the stake bag, ...

> Hello all,> I am currently in the market for a new to me glonass capable base rover system. You are probably going to read this and think "wha...

It will rerun the commands by tapping the space bar.Labeling and 2dline is where I rerun the last command the most.On my old laptop, now wiped of Carl...

"New Hardware (new hard drive, network card, new computer) - Specify this reason when an underlying computer hardware change (e.g.installation of a ne...

> You are on the right track man> > With Carlson, a little bit of a tip, use the external files that the program creates instead of the CAD e...

Thank you for your help!!!!!

EXPLODE just worked as my temporary solution,but I am still looking for an answer for my regularly occurring TRIM refusals.Thanks