The request begin when they tried to import the drawing into Google earth. They sent me an email asking what coordinate system I was using. The info w...

I wonder if it can be done in AutoCAD if its a simple scale? That would same me a 60 mile trip to an engineer's office.

Will the Civil 3d points scale vertically by adding the extra 0 to the scale command

I would go from L1 cross the road intersection to C1, L10,C2,L11 cross the road on along the common line go to L2 and circle clockwise to the point of...

Operations of law move boundaries between owners, but they do not move or multiply corners of the PLSS. ?ÿ So are you saying a division of a section c...

The neighbor told me that her daughter said he walked next door to her house and started taking pictures of the license plates of the vehicles in her ...

The neighbor told me that her daughter said he walked next door to her house and started taking pictures of the license plates of the vehicles in her ...

Funny thing, I spend many hours at the local clerk and recorder and assessor's office and never run into other surveyors from the area. There is no on...

I usually respond with my hourly rate, then break down the project into field, office, research and driving time so they can see how quickly the cost?...

I usually end up surveying the adjacent parcels even if I have a good deed

Carlson has a lot of nice routines for surveyors, but for general drafting you can't?ÿ beat AutoCad or Civil 3d. Just my .02

?ÿOnce you connect go to the Localization then GPS tab, press the icon that looks like a GPS rover next to the scale factor and SurvCE will read the g...

I'm was using SurveyPro on Ranger 300s. I do have a friend who purchased Hiper Vs not to long ago

When I?ÿ bought the first 2 units, they were already set up. The original owner did send a couple of CDs but I think they were for Windows XP. I'll ha...

I'm using Carlson, I use the polyline report, but I do check it with the AutoCad list command, I do not believe I would get any difference if I assign...