For those setting their robot back to the dealer for calibration/certification what are the typical costs for the service?
I'm assuming a range from just running a quick calibration all the way through to pulling the skin off and regressing etc.
In the neighborhood of $600 if you didn't purchase a maintenance agreement.
My MS60 was over $1k including a full on service. But that is good for 2 years. The dealer's shop rate is well over $100 an hour.
Those are more like the figures I was expecting assuming they open then up and check inside also then run the calibration.
A colleague who uses one of the Carlson badged Geomax Zoom90 said when he sends his back the check is ~$200 which I though would be hardly enough for service center to even run though the calibration routine.