Can you send me the drawing to look at? jason dot gordon@evwilliams dot com

> Our parent company uses Civil3D and we use Carlson Survey and we have had no problems at all. We export the .crd file out using the "export point...

When working with large coordinates ie. state plane, the hatch origin needs to be set in your project area to have the ar-* and other special hatch pa...

Yes there is.

We just refer to it as Global Positioning Sometimes.

When using the stockpile command, I use grid cell size of 1' or down to 0.5' depending on size of the piles or type of pile. Are you using the number ...

The drainage portion - be prepared to do channel calculations, erosion & sedimentation control practices, storm water design standards, general st...

Never install any of the toolbars offered, I use malwarebytes and adaware on top of our company installed virus/malware scanner. You may want to make...

I never had problems with the earlier versions of SurvCE when I was using a Geo600.

We use Cisco AnyConnect here

Turn your frames on to edit them. As far as text in hatched areas, select the text as part of the hatch boundary/objects and it will hatch around the...

I use a VPN connection to our network when away from the office. It's like being connected directly to the network, all drives and printers are availa...

I've done a similar thing a time or two, forgetting to put the antenna on the robot and wondering why the radio wasn't connecting to the instrument.

Were there any reflective signs on line with your foresight? Are you running active targets or passive targets?

I was able to get straight in, nothing triggered ant alarms. Will scan to check.

right click and select enter

That's one of a few things Terramodel can do that I wish Carlson could develop.

Set up point groups based on your descriptors, you can then select points by group name.

It's July 22nd. I'll be there.