@paden-cash?ÿ I've always believed the "Pound out the magnetism" theory because is see low signal most often in rocky or hard soils.?ÿ I've also obser...

@bill93?ÿ I think underground power and telco lines act as masks or background noise that make the pin harder to dectect.?ÿ Similar to listening to so...

@bill93 I made two mistakes. I had determined that the 3, 180, 39 combo didn't work so I wrote a loop to find Y's larger than 180 to test in the facto...

You were one of the passengers who exited on one of the lower floors. ?ÿ

I'm half way to a billion with no solution yet. ?ÿ

@spmpls Maybe we're just sitting quietly over here in the corner working on the solution.?ÿ I've written a short loop routine using VBA in Excel that ...

@mike-berry I read the vanity plate as two four-letter words and thought WTH, then I read your post.????

Under the draw pull down menu, select Arc.?ÿ Under Arc are about 25 ways to draw an arc. One of the options is Extend which gives you the option to ex...

@peter-lothian I knew I had experienced the same issue.?ÿ It just took a bit of Googling to find the setting that would cause it. Glad to have helped....

Check the MSLTSCALE value.?ÿ Set it to "0"?ÿ See for a deeper understanding of how MSLTSCALE, LTSCALE, PSLTSCALE interact.

Check your annotation scale on the lower right side of the screen.?ÿ Sometimes it doesn't update when you make changes in Drawing Setup.?ÿ Also, somet...

@lostsurveyor I had to keep uninstalling a particular Win10 update but after a couple months a later update fixed the issue. Mine is a Designjet 800, ...

@andy-j Right click on the osnaps icon in the lower right toolbar and it should bring up a list of snaps. You can check or unchecked as needed.?ÿ I ke...

If you've been running as a network rover then the base will be a big help.?ÿ?ÿWith the first gen R10 you're not going to do as well in the woods due ...

Also, sometimes if you've upgraded software or drivers on one device but not the other, you can get a situation where things are not compatible.

If it's site specific then I would be looking at interference.?ÿ There was an issue awhile back where turning off WIFI cleared up problems with the 2....

August 4th, 1989 courtesy of the U.S. Army from Knoxville, TN to St. Louis, MO for Basic Training in a small twin turbo prop.?ÿ I don't remember the m...

@norman-oklahoma I usually go a different route.?ÿ I start widening my search area looking for the real corner.

@field-dog Smooth rod and usually a wire clamp in the top 2-3 inches.

I'm pretty sure it's turned on by default on fresh installs, or maybe it came over when I imported my previous settings. Just a heads up for anyone wh...