the gs14 has a web interface. on viva controllers there is a shortcut on the windows desktop that takes you to it.otherwise you would type the local ...
Something that hasn't been considered - they could also opt to convert it from the PDF that they have.Any problems down the line with tying in to cont...
I doubt they would blacklist you for not handing them over free of charge. It would be a stupid decision for them commercially.Maybe you could charge ...
3dreshaper is another you may want to consider for extracting breaklines and other shapes.
John Hamilton, post: 441146, member: 640 wrote: I figured it would be more rigorous if there was no "eccentric"component, just straight vertical shot....
John Hamilton, post: 441136, member: 640 wrote: Here is the idea I have come up with based on some of the suggestions...I have a mag mount with 5/8 th...
chris mills, post: 441130, member: 6244 wrote: That only stops them drooping when held on the normal vertical axis. When the prism support axis is rot...
chris mills, post: 440462, member: 6244 wrote: With a normal prism you'll probably need a bit of sticky tape to hold it in place for the "horizontal" ...
A Leica spigot would do that. There are a few ways of fixing them. Maybe screwed to a beam clamp would suit.
or 7.204775 x tan (0?ø0'0.55") = 0.000019i am pretty sure that the adjusted distance is used, but I don;t think it's possible that it could make any d...
It's a new feature added to 8.2 (i think). It's basically the residual angle multiplied by the horizontal distance.So you could see (for example) that...
Maybe he meant that he wanted to run it underground in a pipe?
I believe Starlev is for differential levelling observations.The main Starnet program will apply refraction and curvature corrections.I am never quite...
rfc, post: 436436, member: 8882 wrote: Thank you, Sir! That looks perfect. No, I didn't need the "mirror" line.Is that something that could be done in...
That is concerning. It has been almost 2 years since I used one but static processing with TBC checked in ok then. TBC selected the antenna model. I d...
Frank Willis, post: 434598, member: 472 wrote: I have had Leica and Trimble robots. Still have Trimble S6. My preference is Trimble, hands down, not...
Belated update - I got a refund, thanks!
JaRo, post: 434575, member: 292 wrote: Thanks for the answers. I will have to wait until the "Project Manager" ain't looking and mess with it some mor...
Jose Duran, post: 433886, member: 11714 wrote: As totalsurv said, use a viewport in paperspace, then export to a new drawing.Right-click over the pape...
Erase command. Then All to select everything then hold shift down and deaw a window to remove entities from the selection set. Whether you draw the wi...