@leegreen How did you power the sd1000? Thanks, Steve

@richard-imrie Joe's last name is 'LaCava'

Do you just need one SD1000 plugged in to the instrument port, or do you need one on the FC250 as well? Thanks, ?ÿ Steve

My best effort. Somebody measured something then another somebody 'fixed' it. Steve

@scotland I can justify anything: expensive equipment, research time, drafting time, stringent state requirements, but I never put a per hour number ...

"... I feel much less safe working along highways ..." Amen I am northern cold weather duck hunter spending every fall/early winter breaking ice to ge...

If the bar isn't mushroomed so badly you can't get the cap on without cutting some off, then the road isn't really frozen yet. ?ÿ Steve

There are no dumb questions, remember that.?ÿ What if this was a 5 mile road project and his measurements were consistent??ÿ Wouldn't you want to know...

The bank in the absence of other evidence, but if the adjoiners deeds are to centerline I could easily be swayed Steve

I have the second and the fifth from the top left.?ÿ They wear out a bit faster than I think they should, but the flexibility and layout of the pocket...

My civil design work goes through C3D still. My boundary work is going through ICAD-Civil Survey. I am not changing either workflow. Steve

When I was under similar circumstances to 'Bob' I tried very hard to not give the impression I was in responsible charge, and my boss at the time told...

I had an issue with ICAD printing in model space recently. I ended up opening my file with Autocad, saving it, opening it with ICAD, selecting the pri...

Axle, no doubt about it. Steve

"This is by the square foot urban property, so hundreths are at issue." You're only as good as your control. Both would be justifiable, especially if ...

"I don't ever get to meet those folks. I stay chained to my rover collecting sand burrs in my bootlaces....and I LIKE it that way. " Amen.?ÿ Steve