It looks like a vertical only calibration. Some projects were surveyed in different realizations of NAD 83 or different geoid models. I think from a c...
Getting a good horizontal and vertical location in Wisconsin is a real treat. We have a free VRS system, a very well defined geoid (the whole state we...
I agree I create a code for the building to shoot reflectorless and a code to shoot the adjacent ground elevations.?ÿ
Bidwell why would you red top a bridge deck.
100?? In rural sections 50?? in urban sections.
We have a 755 and it works very well.
I have been cutting my own from 15 yard rolls of retro tape the adhesion seems to be much better than the cheap eBay ones. I do prefer the silk screen...
I would guess 11mm at 50M would work?ÿ
It looks like he used some consistent offset from the edge so I think it was probably easier to draw a line than try to match up a pre printed line.
Could you set 2 points far away and observe angles from both points on the taller trees and run intersections.?ÿ
I don??t know what your using them for but I like to use shallow angle ones for angle only in resections.
does your TS have a retroreflector only mode? If so I would cut the reflexite to fit over a magnet and make a vertically oriented line on the reflexit...
That shouldn??t be a problem.?ÿ
I would say electric as well I would look at the Milwaukee M18 SDS max with a 12Ah battery. I use the SDS plus for chiseling out frozen ground over pr...
Great for ADA ramps
Will definitely run the hiper I am not sure about the grx Sokkia is no longer an option at least in 6.3.1 I cannot remember 5.3. You may need to get a...
I would look into retro reflective targets also they are handy if your setting up a lot of times in one area. Also we have 3 IX??s watch your tilt an...
At least where I work there is almost no demand for grid layout for dirt work as almost every contractor moving a large amount of dirt is going to be ...
I don??t know why the file type but it is nice having points in a separate file that is constantly being saved for when it crashes.?ÿ
The line can be any alignment in the job. If you go past the DTM bouandry it stops reporting cut fill. I cannot remember what it does when you go past...
