Dan Patterson, post: 426774, member: 1179 wrote: That's ridiculous! I guess if they need it better than 2" they better not call that guy againSeems t...

With GNSS using a VRS/RTN network.Locate the BM with 180 epoch.Go to Edit >PointsSelect the BM, Add point BM1Change the Elevation to record elev.In...

Dallas,That's a way more complicated method. If you set the units in Config file I mentioned then a single click to change between Metric and US Surve...

Are you using GPS or Robot?Should use Remote Bench routine.No need for North or East. Tap on the Point Selection, it will change to Elevation. Enter o...

Larry Best, post: 426544, member: 763 wrote: For the second time (in maybe 8 years), mapping that I produced in ,dwg format for highway design was con...

If you need to stake a spiral curve (horizontal) or parabolic curve (vertical), then you must import it via LandXML, otherwise a a 3d polyline will wo...

arctan(x), post: 426473, member: 6795 wrote: So I dont need to try to import carlson centerlines and profiles through landxml. I can just import a dra...

arctan(x), post: 426461, member: 6795 wrote: Does this method work for 3d polylines?Sent from my SAMSUNG-SM-N920A using Tapatalk Yes

Topcon Magnet Field Lesson #24That's for a Road. Sounds like you are staking a polyline.For this go to MAPSelect the Poly line with cursor, so that t...

Change from "Station" stake out to "Real Time".

christ lambrecht, post: 426286, member: 284 wrote: Lee, thanks for the links.I have almost all my codes setup for the survey part.With the old fieldwo...

Duane Frymire, post: 426285, member: 110 wrote: Sent you a private conversation. I am out of the office today working in the field trying it's very w...

Shawn Billings, post: 426222, member: 6521 wrote: Why localize? Good question for original poster (OP)?

The other part of the equation here we haven't mentioned yet is your localization. A general rule of thumb. Take the absolute value of your error show...

cls5095, post: 426171, member: 6344 wrote: these points will be out .04 x .04 plus (your logic). so basically i spent $25000 for a rough layout toolSo...

Lesson to learn. If using Magnet Field you have lost no time or data. Simply apply the correct base Coordinates in raw data of software and recompute.

The best you can expect from layout RTK is +/- 0.04' under ideal conditions. Add any type of multpath and you got more error.With RTK you can set a 2"...

Todd Hunter, post: 425665, member: 11035 wrote: We recently purchased Topcon Hiper V with the FC-5000 and FC-500 using the Magnet software. We have f...

What is a SFM project?