WTF, when did 1987 become vintage? Plus real surveyors don't use gammon reals. They just get hung up on brush and caught in truck doors, at least th...

Have you tried a static PPP solution? You might need to wait a bit longer for better orbits and clocks, but in the long run it may be a better soluti...

While this discussion on fence lines in interesting, the OP states something that seems to be missed in the preceding posts. He states that section w...

I'm not in the office so I don't have the info in front of me, but I plot 18X24 rotated to the landscape so as to not waste paper. I don't think it w...

I would guess this is a scope issue and not an hourly fee question. Unless your office rate resembles a capital defense attorney that is.As for negoti...

azweig, post: 430627, member: 7041 wrote: Rant on...So, we have invested in one equipment manufacturer, GNSS, robot, data collector, etcƒ?? A few yea...

JB,Most of the PDF programs allow you to apply a digital certificate (with a copy of your signature if you like) which will not be valid if any change...

The Bosch is the bomb. Well worth large sack of coin you have to shell out.

I have some 20+ year old Leica legs that are about the same as the current versions and I don't remember any difference for the Wild legs (with the ex...

Closest thing I have worked on is a 4 mile forced main. 2 24" lines, that's a lot of shit and process water.

Joe Ferg, post: 428792, member: 332 wrote: I left a big firm such as that, never happier! Joe,I think we left the same big firm. Much happier 20 yea...

I think all DOT's went metric for a short time in the 90's. The Fed's required it to receive federal tax dollars. That got nixed when Bush 2 came in...

I switched over from the CS15 to CS20 earlier this year. First, the screen is way better. With the CS15, and RX1250 for that matter, I used the x-se...

What timing. My insurance provider just informed me that they would no longer be providing me insurance because of a couple of claims we had this yea...

John Hamilton, post: 427788, member: 640 wrote: There was one jurisdiction in Westchester county, NY (City of Rye, I think it was) that actually made ...

I have been using the GRZ4, GRZ122 & GRZ101 for years without any troubles in workmanship. The GRZ4 dates back to the late 90's and has held up t...

I replaced my DJ800 with the T520 as well. Works great for the small amount I plot. The only problem I'm having is plotting tabloid through CAD. I ...

rberry5886, post: 426914, member: 232 wrote: That was my second term...50,667 votes and I ran unopposed in 2010 also....Daniel Boone was the first Cou...