Jim, When using a static IP address, it is pretty easy to set up a GSM base with Leica. It acts just like a radio vs an NTRIP server. It does have a...

I've had an ML-1M for over 20 years. It works just as well, if not better, than my Schonstedt GA-72Cd which is the same vintage. As I recall, Subsur...

For the simplest approach to a GSM approach, the base will need a static IP address. That way you can broadcast directly from the base. With out a s...

Mark, You need to get out around the state more. SE Oregon, SW Idaho & N Nevada are way more desolate. You know its desolate when you have to ma...

I'm loving my AP20. For topo I'm amazed how many things I've been able to get without another setup just because I can lean the rod out a bit. It ha...

Not 100% sure, but I thought the current version of Captivate would import IFC files. You might want to check that out.

I think those specs are for distance measurements only. The MS60 data sheet states it will shoot a distance over 10000m to a circular prism, but the A...

I'm going to be the voice a dissent on this one. Stay with the Seco, I'm going back to them. As I posted back in 2020, I think they have a problem w...

Ditch the bi-pod. If you are truly worried about accuracy of your control, then utilize stable back sites and fore sites. And that is not a bi-pod, ...

why does it seem like no one else uses RTK over cell? It is just so much easier than having to worry about the radio coverage…. That had been my go-to...

Let's not blame the computer, that's a user error. In fact, C3D can be used to weed out a lot of those calls automatically or semi-automatically if t...

Theoretically a base/rover RTK setup should be good for around 15 km, radios will be your Achilles heel. If you have access to a repeater radio you c...

Can't help you there. I rarely use DTM surfaces for layout and when I have, it has been a relatively flat surface, so I just use the height offset. ...

The geoids need to be stored as GEM files. I've always used LGO or Captivate to create them by extracting my area of interest from the binary file. ...

Went into the office. The off brand GEB 221 that works with my 1201 is from UpStartBattery dot com

Its most likely a battery issue. Lithium ion batteries have an onboard chip that communicates with the devise/charger. If it is not programmed corre...

You can download whatever you want from my world, it just won't load on an instrument without the proper CCP date. Myworld is notoriously slow. I have...

I never used the 'Leica Instrument Tool' on our TPS1200s. All firmware and keys were loaded directly from the CF card, just as they are on the most c...

Nice work, what kind of hole saw did you use? I must have a very short pilot drill.

When you import the XML file, you assign it a job name. That job name is the first part of its folder in the DBX folder. The alignment/DTM jobs creat...