The high-flow manholes I've seen wouldn't allow diversion - the flow would take the diverter downstream, either into the pipe or blocking the pipe at ...

I may be facing a similar situation soon, though with inverts in the 20' range. What I'm planning to try is 3/4" aluminum rod sections - the kind tha...

I would think it'd be simpler and more statistically valid to adjust the project on the grid and then export ground coordinates afterward.

Charles L. Dowdell, post: 396216, member: 82 wrote: never had any compensator hang ups with either oneI've seen the compensator hang up on an Ni2, but...

HICALS, post: 396223, member: 6788 wrote: Also, is anyone aware of any publications available on the subject matter?If you mean dealing with GPS vecto...

HICALS, post: 396223, member: 6788 wrote: I am assuming that the in line command utilized in Starnet would be the same as for slope distances (DV).Sta...

I use Leica prisms pretty much exclusively these days. For most work the GMP-102 mini is my choice, but on those rare occasions that I need to shoot ...

JKinAK, post: 396203, member: 7219 wrote: We keep the cut line low so that we don't leave a bunch of stobs sticking up - travel is better and you won'...

I'm scratching my head wondering why anyone would want to use PC-to-PC vectors for anything. I don't think I've ever done it.

The sites I typically work don't lend themselves to automated sections - there are too many trees and other obstructions that get in the way. Instead...

Holy Cow, post: 395907, member: 50 wrote: That's why it has been more than a couple of decades since I have operated one.It's been a couple of decades...

The few times I've used a simplified method for an EC I've included a report detailing how I developed the BFE, and the whole package went to the coun...

FL/GA PLS., post: 395694, member: 379 wrote: Do you use an add-on package for surveying tools or does BricsCAD include a basic COGO set of commands?Th...

Bad working weather for me, from bad to worse: heat, cold, wind, fog. We don't have snow here, so "cold" for me is anything below 50å¡. And I don't...

Dane Mince, post: 395593, member: 296 wrote: The issue in part is trying to figure out a relistic budget. I am not clear which is cost effective 4 mil...

Kent McMillan, post: 395514, member: 3 wrote: 120-minute sessions for 2-mile vectors may be overkill. I'd rather have two 60-minute sessions on two di...

My $700 full-price purchase of BricsCAD Pro is looking better all the time.

back-chain, post: 395420, member: 7900 wrote: and ask for the descriptor before you move the stylus away from the 'shot' buttonThat word "stylus" is t...