erwsdot, post: 440681, member: 6038 wrote: The screen on our Carlson Surveyor + is going out.I don't like to hear that. How old is your Surveyor+, an...

I've never encountered a fence like that, but if I did and going around wasn't feasible, I guess I'd be looking at making a temporary cut down low and...

John Hamilton, post: 440535, member: 640 wrote: Not a tower, a four foot stand.Looks more like an 8-foot stand to me.

Scott Zelenak, post: 440262, member: 327 wrote: Misidentified stations are the crews favorite torture for me.Same here. And I'm the crew!

John Evers, post: 440225, member: 467 wrote: Static processing and report generation are directly handled by the LSThis only pertains to data gathered...

Shelby H. Griggs PLS, post: 440203, member: 335 wrote: Does Javad have an office software package for post-processing and exporting data for control r...

I ran into this yesterday with a zip file. I resubmitted the RINEX and it worked.

I'm surprised that no one has raised the issue of a criminal conspiracy to defraud the auctioning party.

I just finished reading the article about the Ecuador expedition. More great work from Gavin! And it was fun reading that most of the team members a...

Shawn Billings, post: 439186, member: 6521 wrote: I was a big proponent of developing a total station data collectorDoes this mean that the J-Field to...

tomarneson, post: 438624, member: 864 wrote: Leica has a factory in Singapore.Accordingly, I revise my earlier statement as follows: I have little do...

If you want Leica quality without Leica pricing, take a look at GeoMax. The guns are a generation back, but aside from color seem to be genuine Leica...

I've been using Access for this purpose for 24 years, but in a pretty bare-bones way. It works for my one-man operation, but the way I've set it up i...

Leica employees are too busy trying to keep up who owns their company.

My GeoMax Zoom80 is indistinguishable from a Leica TCRP1202 save for it's color. Part numbers are different, but follow the Leica convention. I have...

Williwaw, post: 438489, member: 7066 wrote: I haven't attempted it but I'd be inclined to heat the cap and take a smooth face hammer to the surface wh...

superfly, post: 438410, member: 8421 wrote: So if you mix older models with new ones would that make a difference?Antenna phase center modeling is pre...

I've used a die grinder with a carbide bit. It works, but you have to be careful not to dig too deep. The bits are brittle, so you also have to be c...