Maybe a bad battery? I would try cleaning the contacts with an eraser too. I have never seen that error. Also, pull the battery and leave it out overn...

Thanks for posting this Lee and once again it was good talking with you. I sent my P4P in today and am already anxiously awaiting its return. Gregg

There is a first edition, (1957) on ebay for $75.

I went to work as a corrections officer when I was 22. It was a great paying job that changed my path in life in a good way. I hated it though and sta...

Yes, I have an AAS in Forest Technology with a concentration in Surveying but now they have an actual AAS in Surveying Technology since the Ranger Sch...

It seems like a pretty good gig. I was a consultant working with the outgoing surveyor. He checked my work as well as did other surveying duties. He s...

Check out the Western States Cabling website. If there isn't one listed, I think he'll make you one. ?ÿ ?ÿ

Well, the engineer is only going to provide a few more spot elevations. I told the contractor that there are a few areas that I'm not comfortable with...

Yes, I do have the CAD file.

I have never used a USB to download a 5700, always a 9 pin to limo. I think the program you want is Trimble data transfer and it's a free download. Gr...

I have not. I assume it's the same test as before. Mine comes up in April. Gregg

I'm not sure how your DC software works (access I assume?) but with survey pro I would just use the remote control screen in the foresight tab and ref...

I have used gas powered and electric powered jack hammers to drive #7 rebar down to 5 feet. We rented the equipment from a rental store. I think the c...

So the point cloud is good but something gets lost in between there and the DTM? I haven't looked at the point cloud yet. Are there any ways to resolv...

I bought my first plotter last year. A Canon IPF670e. It's pretty slow but the quality is good and it was less than $1000. Gregg

First off, thanks for the pdf.?ÿ I haven't read it yet so I'm sorry if my next comments are covered in there. Are you basing the overlap issue on the ...

In the contour lines section of the additional outputs tab in processing options my resolution was set to 10cm. Is that what you were referring to? Gr...