Lee D, post: 398475, member: 7971 wrote: As far as I can tell it's not supported in Access. Not sure about a 730 but I have used Access with a 930 be...

Use mine with a R-8 and a 360 prism with a TSC3 on the same rod, but you have to keep it lower than 2m. Mine is set at 5.50' for the prism. When I r...

bob james, post: 394009, member: 12050 wrote: So you are saying, if I understand correctly, with P24, you can just elect any two points that are in yo...

Was going to sleep in a little this morning because nobody had requested anything for early. Heard the phone ding with a text message this morning at...

John Hamilton, post: 392863, member: 640 wrote: the vibration happens on "inferior" tripods. That is why we use the trimax. That is a known issue. Not...

First question is which rmt do you have? The ones for that instrument are about 6-8" long. The diode should be under the prism and on one side, don't...

Post a picture. Maybe somebody will recognize it.

Done it many times flagging highway RW clearing lines. But always too much cover to be in front. Usually pick a line that will run straight thru and ...

So I have to read some settlement platforms weekly at the end of a 40' fill for a bridge end. Nothing to put a BM on except a culvert headwall at the ...

MightyMoe, post: 388991, member: 700 wrote: You have a file with finished grades, you are staking with your rover and want the cut/fill to display the...