But wait, are we talking NGVD29 OR NGVD29(47)?

I use "use drawing scale" so points are shown relative to the scale i'm working in. As far as size goes it depends on what I am using the points for. ...

I too zero the elevations when processing.

Maybe you are asking the wrong question> How do you get OUT of surveying?> > It's a lifetime disease!> > :)> > NThat's funny stuf...

I agree with brinker, I don't think you can. Not sure how you would tell Civil3D to use your linework code set without going through the "import surve...

Now that I reread your original question I see I'm 180° out. Talking about getting drawing out rather than cleaning up a template for in-house use.I k...

For getting products out to clients, that have Civil3D, our current resolution for this is to have everything on and thawed, then WBLOCK the model spa...

did you check the "connection settings" in mobile device center?

No, they all unchecked with no message at all.

I have no idea why unchecking the "Enable advanced network functionality" box worked for us. I do know that when our company switched to Windows 7 64 ...

Assuming you have Windows Mobile Device Center installed.Start menuSettingsConnections tabUSB to PCuncheck Enable advanced network functionalityon mos...

In Civil 3D 2014: Modify tab, Design pull down on ribbon, Convert 3D to 2D Polylines

This PDF may have what you need for the 5600, beginning on pg 115, if you have a faceplate.

We had the exact same problem with our Rangers/TSC2s. The light should be blinking evenly while charging, not blinking and pausing. After fighting wit...