Jim Frame, post: 358640, member: 10 wrote: I unchecked Intelligent Zoom and that helped some. It's still jumpy, but better. Thanks for that tip! ...

Do you use Carlson in the office? I am curious about the custom built F2F. The Carlson f2f is customizable so you probably could use your existing F2F...

Jim Frame, post: 358634, member: 10 wrote: Bingo! The "T" thing doesn't make much sense to me, but at least I now know how to do it. Thanks! P.S. Is...

I use the find point option too (view, find point), which will find it and zoom in to it.

Enter T, then green check, it should then prompt for point id, enter and enter magnification, then green check.

Exbert, send them to apsurveying at geee mail , i will try to convert them.

I use EarthExplore, It is slow but it does the job. I too would like a better way to browse historical photo's. :good:

sur04, post: 357988, member: 10101 wrote: I want to thank everyone on the input and advice that you have provided. I am trying to gauge what I need to...

fattiretom, post: 358127, member: 6039 wrote: So since my Leica MS50 was destroyed (frame bent, circuit board broken, radio handle broken) it's just t...

In Survce, Equip, Load robot, Search, check turn to point in stakeout, uncheck turn to vert. point in stakeout

Welcome aboard

James Fleming, post: 358033, member: 136 wrote: I have more of a problem with state boards who micro-manage the actions of licensees to the point wher...

A couple of my biggest clients are PLS's. I always hand over a map or report just like I would if I were working for the public.

Plumb Bill, post: 357930, member: 226 wrote: How well does it work when importing files generated in Civil3D? Or do you do much of this? I haven't ...

Plumb Bill, post: 357924, member: 226 wrote: I was wondering if anyone has tried to switch to this from AutoDe$k recently? Was mostly wondering how st...

Try searching this forum (top right corner of page), there are hundreds of answers to each of your questions tucked away right here.

I have 2 Epoch 50's that have proved very tough and reliable. I use them as a back up now and have been debating with myself about selling them, if an...

A Harris, post: 357647, member: 81 wrote: I am attempting to redraw a drawing that the file became corrupt in August, 2015.A "FATAL ERROR" opened and ...

Dan B. Robison, post: 357659, member: 34 wrote: How about a spinning one of these? DDSM:beer::beer::beer: I recall spinning a time or two after an ...