Set 2 rebar control points. Provide coordinates on state plane and NAVD88. Open site, 20 miles from your office.
$400
What are said control point to be used for?
$500 for anybody else
For Snoop I'd do it for a fifth of Maker's Mark.
Depends. Control for a drain field, a high rise or what and how precise is needed?
jud
send the kid
scale it off a quad
$50
.
.
🙂
$1,200 and I'll hire Ted to do it...
Sorry - accuracy to be .1' hor/vet
I am thinking $500 sounds fair
To be used to layout a couple of pumps and some curbing. Basically they just need state plane bought on site.
Two static points, two hours per receiver.
$250/day, per receiver = $500
3 hours field = $255
1 hour office = $50
$805.
But, $500 is fair. My gear has been paid for a while now. $800 is what it should cost though.
$500 for the 2 rebar sounds fair...................But I am charging another $700 for the crew.
$990, this week only.
I'm thinking that a couple hours of OPUS plus a static vector between them would more than do it. A couple hours in the office, travel time. Basically what Kris has. $500 sounds reasonable.
One point 19.95 plus S&H but if you call in the next 20 minutes we'll throw in the second point absolutely FREE! you just pay separate shipping and handling.
And ask us about our free thank you gift, an open line of sight between your two points. If you aren't completely satisfied with your points, just send them back for a full refund but you keep the open line of sight as our thank you for trying the two points.
1-800-twopoints
or log onto www.twopoints.com
Ted has it right for my area. About the going rate. Anything more and you'll be sitting at the house.
399$, but only if you ACT NOW!
:coffee:
Do any of you include reference marks for the two points, so as to be able to show they have or have not been disturbed in the future, or replace them if needed?
Bill, you just run right out there withe the GPS and re-set... for slightly more than the original cost 🙂