Last seen: June 4, 2026 10:08 am
@holy-cow Two sides to every coin. I like not having to deal with having to hunt down work, deal with clients with unrealistic expectations, champagne...
Just a shoot from the hip WAG but looks like there is a missing dimension for a short tangent in SE corner of Lot 12. The arc labeled 50?? looks like...
What a wonky back lot line. Sometimes when the plat is too difficult to read I??ll comp the boundary and insert a tiff of the plat and scale it to th...
We've got a pair of Kenwood radios. Hardly ever use them any more. Remember when we were working near fast food joints we were always picking up the d...
Not sure if I should read your post with an Aussie accent or a Florida Cracker accent, but in any case welcome to the surveyor mosh pit mate.
One of my old mentors was fond of saying, "Their lack of planning and preparation, does not constitute an emergency on my part."
Taking tests has never been my strength but the one thing I've found that helps me the most is getting my anxiety under control. The assumption is tha...
It??s a good question. IMHO what defines a ??Cadastral?? survey is the original survey of public lands to create original boundaries by either the ...
@ladd-nelson Copy that. Cleaned everything up in this one, bit tedious. Happens again and suspect it will, I'll bounce a copy your way. Thank you.
Have this John Ruskin quote on my office wall. ??It's unwise to pay too much, but it's worse to pay too little. Whenyou pay too much, you lose a lit...
@ladd-nelson Thank you Sir. I'll give that a go. Drawing is set up in a standard SP Projection but I'm still getting a handle on what all boxes to che...
Does nobody break out the gun any more? ????
I can see how a layman might jump to the conclusion that a bearing on a plat is part of a latitude and longitude coordinate because they use similar d...
Thanks. Will give that a shot. ?ÿ
I used the 'Create Points from Entities' with the line work to verify the line vertices were actually shifted off of the nodes, but otherwise in drawi...
First thing I do is check that 'Locate on Real Z Axis' is not checked. I will double check 'Additional Draw Options'. Thanks for the suggestion.
Mike, I spent some time on the phone with Carlson and they suggested that it might be that the view vantage was inadvertently getting skewed so it ap...