@loyal Thanks TEQC worked.

Xref the drawing you want to scale into your target drawing. Before you do so set the INSUNITS of your target drawing to the units you are working in ...

I am an employer

I think the point is that what he is being asked to write down is already recorded in the data collector file.

I agree. This is all recorded in the raw data file. I don't see the point of writing all this down when it is all recorded in the raw data file. I wou...

Not much good without accuracy as well. You can precisely hit the wrong point many times.

I think a reasonable expectation of accuracy could be stated with the caveats above.

Thanks Lee, would you normally uninstall the existing version on the controller first.

Lurker can I ask what data collector you are using and did you try a different data collector to see if there is any difference? It seems if you do a ...

The thing is this never happened before I sent it in for calibration so I suspect something has gone wrong in the shop as it was working perfectly rig...

I have had the issue with Autolock on as well unfortunately and it's always on the correct target. The thing is it was working perfectly fine until I...

Is it likely to occur again? If it was just a one off mistake on their part and they are good employees let the company pay it with a warning that nex...

Yes this is what is happening. Is there anyway to reinstall Survey Controller.

Anybody using Survey Controller come across this?

Thanks all I will try the suggestions above. I am hoping to be able to maintain a link to the .crd file after moving. I think the update crd from draw...