Thanks for that Ladd, I just made the jump to 2021 and I need to go back and look at that.?ÿ I'm just happy that Intellicad finally got the message an...

Do the points still show up in the coordinate file?

Same issue on Chrome on a Win10 desktop.?ÿ Works fine on Chrome on Android.?ÿ I ended up hitting F5 and Alt F5 with no result, but accidentally hit I ...

@john-putnam Architects must be taught the same way. Probably ninety percent of the house plans i get where the garage is set at an angle other than n...

Early in my career I was squatting down driving an 18" wood stake on a hot summer day with a 3 lb. Estwing. I finally missed a stake and the hammer's ...

I like SurveyorConnect and I've always felt like RPLSToday is just a little too close to the name of that other site that died several years before th...

I'd have never heard it without knowing to listen for it,?ÿ but I believe that f-bomb in the background is between 0:50 & 0:55 in the version of L...

@bill93 He's popped on FB a bit, I believe the last was only 3-4 days ago.

@ralphieboy the latency still exists with an S7 / T7 combo.?ÿ I suspect that it's a function of image size and the speed of the radio link.

Measure from the physical center of the prism to the corner you're measuring. With the MT1000 I typically use 0.15' on outside corners if I'm able to ...

I used the Yuma2 for several years and then jumped to the T7 aka Yuma7 as soon as it was available.?ÿ I use it in the rain more than I care to admit a...

It works on my Note 20. You just slide your finger left to right or right to left on the space bar and the cursor moves just like the animation above.

@bill93 that may be true, but I can tell you from experience that shooting brick house corners at 30+ degrees off angle with a Trimble S6 does not giv...

I've used Topcon, Leica, & Trimble.....one of them uses RL in their documentation.?ÿ I just can't remember which one at the moment and lack the ti...

Maybe RL=Red Laser. ?ÿ

CAD makes the shaded fraction easy to figure out.?ÿ The answer is 1/3 is shaded.?ÿ I don't feel like working hard enough to figure out the trig this a...

He'll be missed for sure.?ÿ?ÿ

@paden-cash I use a 1/4" bit for the 1/4" magnails but I always drill the hole a bit deeper than required then fill the hole in with the powder left o...

@bill93 The man also has on gloves at 20 each.