Thanks ....I'll check that out.

Got it ...thanks! I deleted all instances of the block, purged, re-ran FTF and all is good now.

Per the 2011 standards.

This is the first thing that came to mind, I just didn't know if it would be the wrong thing to do. Like you said, if the parties are comfortable usin...

Right. I'm not looking to be nice or do them a favor. I did a good bit of work for this company 5 Years ago, but the person I worked with then has mov...

To be completely honest, I don't know yet if the site and commitment are exactly the same, but I know what my answer is to them if there are changes. ...

FYI - A 800'shot for vertical is pushing the limits of most instruments even if it was doubled. You will always see a vertical difference (at that dis...

Sounds like it's time to run through the collimation routine to me. A vertical index that's out or tracking that is off will cause the errors you are ...

I've used early Topcon robots, then Leica and now a Trimble S series robot and have had all of them grab my vest (reflective strips) at some time or a...

In a Zone A, the natural HAG (pre construction) is used as the BFE (unless you have one established) to rate insurance. If the lowest floor is less th...

I've been involved in quite a few of these in my area since the new FIRMS came out in 2009. If they want insurance, Section E of the elevation certifi...

Exporting a .job/.raw out of the collector is the best way I have found too. I still have a copy of TDS Foresight/DXM that is nice for viewing .raw fi...