Activity
 
Notifications
Clear all
paul-in-pa
@paul-in-pa
Registered
Joined: Jul 3, 2010
Topics: 700 / Replies: 5344
Reply
RE: Changing setup details in 'Convert to Rinex'

Once RINEX is written a text editor can be used to change antenna parameters. Using Notepad or equivalent is easy. Paul in PA

3 years ago
Reply
RE: And which is Lot 1?

@toivo1037 You have sufficient information to survey Lot 2, but what does your client have title to, East half, West half or both? Without a title se...

3 years ago
Reply
RE: OPUS Headaches

@geeoddmike As to that P2 problem or one like it way back then, I had correspondence with the OPUS-RS folks and reminded them that RSGPS would take e...

4 years ago
Reply
RE: Transmission Line over an abandoned Railroad Easement

So you say the power easement was acquired from the individual who had a reversionary right to the RR bed and that somehow that RR bed was not include...

4 years ago
Reply
RE: would any surveyor out there no what these numbers are on this field note page I have from an old surveyor. circa 1983

?ÿBStrand is not quite right. Angle right is assumed, but more common than angle left. The distances were slope measured with a 200' tape (very like...

4 years ago
Reply
RE: would any surveyor out there no what these numbers are on this field note page I have from an old surveyor. circa 1983

Those are field notes from an instrument and 200' tape survey of 383 Dover Road (Route 513) from March 29, 1983. They might be useful to a professiona...

4 years ago
Reply
RE: Hello from Westminster, MD

@z1169ss Having used numerous GTS-3Bs, GTS-3Cs, GTS-200/300s, a 5" instrument is sufficient for your purposes. I would suggest a TDS or SMI data coll...

4 years ago
Reply
RE: Hello from Westminster, MD

So? start with the questions already. Paul in PA

4 years ago
Reply
RE: Anybody else having trouble with OPUS-RS (aborting)?

@big-al I am not at all familiar with the teqc commands, I use WINteqc, which guides you through it. I ran WINteqc, chose your file, selected GPS onl...

4 years ago
Reply
RE: Anybody else having trouble with OPUS-RS (aborting)?

You may be confusing OPUS-RS with your data. First off, Comment Line 12 says you Are providing 7 observables; L1?ÿ C1?ÿ D1?ÿ L2?ÿ P2?ÿ D2?ÿ C2 But t...

4 years ago
Reply
RE: Pulled base receiver legs before turning power off, trimming bad data

An Ashtech receiver would say "antenna is moving". Used those markers to trim files when the wind blows my setup over. Just recorded when I set it bac...

4 years ago
Reply
RE: Opus rs issue

OPUS-RS requires quality observations, not only in your RINEX file but also in the CORS RINEX files it is trying to use. Very often it can take extra ...

4 years ago
Reply
RE: Measurement of HI with a metric steel tape - ? of Does it Matter?

@gisjoel I know of no source for a 2 meter folding rule, but Ashtech had an aluminum/fibre? tube scale with a bungy cord linking the segments, which ...

4 years ago
Reply
RE: Measurement of HI with a metric steel tape - ? of Does it Matter?

@thebionicman I stand by my statement. I learned this way back in Boy Scouting, "if you cannot teach someone what you are doing, then you have not ye...

4 years ago
Reply
RE: Measurement of HI with a metric steel tape - ? of Does it Matter?

HI error measurements are random and in a large group of measurements they tend to cancel out. Whether or not I need elevations for a project I carry ...

4 years ago
Reply
RE: Old Drafting Tool?

Considering what I see. I see a steel lined upper edge to run a sharp blade along. Inches and feet and longer than 3'. Most likely a parallel rule, fo...

4 years ago
Reply
RE: WM (Wild-Magnavox) 101 Satellite receiver

I have a similar Magnavox antenna ASSY 819646-801. It has the same bottom section, you are showing it upside down, but has a cone shaped top. Remove t...

4 years ago
Forum
Reply
RE: Water flowing uphill on the ellipsoid

Water does not flow up hill, since up a hill is defined on the geoid. Just because a point has a greater positive value above the ellipsoid does not m...

4 years ago
Reply
RE: Baseline

First off a Baseline is between two control points. The Base is a control point, the Rover by definition is not. Re-ask your question and does your s...

4 years ago
Reply
RE: Fred Dearyan, PLS 902, State of Arkansas has deceased

Condolences Nate. Typically in an obituary, is added, "He is survived by so many grandchildren and even great grandchildren by now." It has been a lon...

4 years ago
Page 2 / 303