Activity
 
Notifications
Clear all
Norm
@norm
Member
Joined: July 27, 2010 4:35 am
Last seen: November 19, 2024 1:40 pm
Topics: 80 / Replies: 1211
Reply
4 years ago
Reply
RE: How is centerline, and stationing defined?

yes, yes, yes and all of the above.?ÿ You're welcome

4 years ago
Reply
RE: Certificate of Compliance Rejected

I had a similar experience. When my client hired an attorney the willingness of the city to work with us changed immediately.?ÿ?ÿ

4 years ago
Reply
RE: PLSS: A Good Way to Spread Error or to Rectify It?

Following lost corner procedures spreads error. Following retracement procedures isolates it. In reality however truly following retracement procedure...

4 years ago
Reply
RE: When title and boundary disagree

Actually there is more to title than 5 acres. Title is evidence of ownership > a bundle of rights > an unwritten concept. A house built on a 5 a...

4 years ago
Reply
RE: When title and boundary disagree

I disagree with the premise of the thread that title and boundary disagree.?ÿ Title is what (5 acres)?ÿ Boundary is where the 5 acres is located.?ÿ ...

4 years ago
Reply
RE: Expected differences in measurements

"We have become very good at measuring our mistakes more accurately."?ÿ?ÿ ?ÿ

4 years ago
Reply
RE: How would you make this close?

I'm reasonably sure the description errors would have been updated had it not been absorbed. At this point its just a curiosity.?ÿ

4 years ago
Reply
RE: Plat symbol interpretation

Law The plat shall show and identify all monuments necessary for the location of the parceland shall indicate whether the monuments were found or pla...

4 years ago
Reply
RE: Where am I today?

I own a 60 x 120 sand box about a mile out my dad bought about 50 years ago.?ÿ

4 years ago
Reply
RE: Acceptable practice?

Measurement Minimum Standards?ÿ The relative positional tolerance at the 95 percent confidence level shall be as follows:a. For subdivision boundarie...

4 years ago
Reply
RE: Setting out a bridge

Gird or ground aside - If the bridge was designed 300 m in length I'd make sure it was staked out 300 m in length as measured with a total station usi...

4 years ago
Reply
RE: Magnet Export Raw Data

Correct setup in mjf job file using edit raw. All points shot from setup will be recomputed in the raw file.?ÿ

4 years ago
Reply
RE: Topcon Magnet Field - Map Background Color

Configure / Global / Under Main tab Color scheme at the bottom of page.?ÿ

4 years ago
Reply
RE: How To Translate Control from Network to Local.

friends don't let friends localize but since you aren't my friend yet check out section 4-19 Good luck

4 years ago
Reply
RE: Hurricane in Iowa?

Geez Bill - that's just weird. Looks like we were thinking along the same line at the same time. Hope you're ok. What a mess! It was just picking up a...

4 years ago
Topic
4 years ago
Replies: 2
Views: 4
Reply
RE: Rifle Barrel for Corner

That gives a whole new meaning to shoot the corner.?ÿ

4 years ago
Reply
RE: Topcon FC-6000 Wonƒ??t Turn On?

I run a 5000 Juniper. I do the hard reset once a week on the average. Hold power button until all lights go off. (15 seconds) Then it HAS TO BE PLUGGE...

4 years ago
Reply
RE: Interesting thinks determined from an old bench loop

The T in TBM is there for a reason.?ÿ

4 years ago
Page 25 / 65