If I had to do a lot of points I would use Carlson in the office make a line through the center of the property then make that a centerline offset tha...
I am running survey pro 6.3.1 but this option has been around a while it??s in the DTM menu. You have to import the surface/DTM file either DXF XML o...
You could stake a DTM and use any line as the refrence centerline?ÿ
Is this for topo or layout
Could you stick a target on the outside of 2 windows on each floor shoot them from the outside. Then set a point on the inside perpendicular to each t...
Measure your bed then put that in cad. Figure out the best way you can arrange your equipment and supplies. Draw that out with dimensions and check wi...
Look through the manual there is a setting for to have it track prisim center it is a little slower also try running a tilt and collimation and a imag...
I will check Monday I know survey pro will use a xml or dxf for a surface. The dtm were the tds surface files I haven??t tried one of those in a whil...
I don??t think it has to be a cardinal direction just approximately 90 degrees between observations.
Try building a circle poly line then stake to line check the east or west quadrant edge of form then the north or south quadrant and adjust based on t...
I missed a check box thanks had points checked but somehow forgot to check linework.
It??s just an ascii file so I don??t think that would matter
This is a good read I would worry as much about procedure as closure.?ÿ
Are there bars sticking out of the caisson??ÿ
7? x 3/8? landscape spikes with a wire pin flag for grade. If you need to set hubs sds max drill with 1 1/4 bit and a generator. We did miles of r...
I would think you would link several systems. Radar for accident avoidance. Some kind of stripe detection system for lateral movement I know Chevy has...
I can get to I no problem?ÿ
Couldn??t you load in a DXF and just stake to line and pick the line or radius point?ÿ
I am running intellicad 8.3 I will try your suggestion when I get back to the office. Thank you
