@rover83 Local regulations are a minimum of 1-1/2” metal caps on 5/8”x24” rebar for all Lot corners, minimum 2” for exterior boundary corners. Metal...

On a plat for a section corner tie I show .001” which is roughly 0.1’, really within .05’ because of rounding. Show epoch and understand that it’s an ...

@samthesurveyor “PK Mag nail” That’s not acceptable as a property monument, nor is an X in concrete. Set a real monument. Stamp lot#’s and lines on...

We all have experience with these types of lots, that building needs to move west asap, there isn't room to place it there. You're in the setback line...

That may be part of what recording laws get us. More basic data. Maybe However, this is a recording state and there's no lack of information to ...

Commercial swimming pools? Are these pools empty? Cause if they aren't empty then the scanners won't help. We did a bit of that for local pools, it...

Depends what I already know about the area. I don't look at the GIS for much more than addressing, flood areas and zoning. But, if I don't know mu...

Since then, every property must be reappraised on a five-year cycle whether resold or not. There are a couple of court cases working through the sy...

I declined to participate! I chased that work as a new surveyor, had about the exact same experience. The few times I did work for the USFS it was ...

these lines, “I’ve never lost a dollar on a job I did not get (“win”)…” Depends on the hours spent bidding. There were some boundary RFP's from th...

My profitability has soared once I stopped bidding jobs. Simply the act of bidding is overhead that cuts into your bottom line. Jobs not won equate to...

I've got a good mind to tell him sorry, we just picked up another big job and won't be able to get to you for another month... It's probably more p...

I believe Kenigsberg might well have a $1.5million house for free.

Just add .01' to his short lines and subtract .005' from each neighbor.

It's simple, you need to know exactly how far off your positions are, correct the base in the software file that much. Recompute the file using the co...

To clarify my question, what questions might you ask to determine whether the pipeline location or the description will be held? I will implore yo...

In my experience it's important to correct the native file. If you do this in a secondary file such as AutoCad or StarNet the connection to the base p...

@mathteacher Yes, or any large area coordinate system. I haven't done a 10,000, 10,000 job in a very long time. Even during the TS days we had exte...