AI Assistant
Activity
 
Notifications
Clear all
lurker
lurker
@lurker
Member
Joined: December 5, 2014 5:56 pm
Last seen: June 5, 2026 8:55 pm
Topics: 8 / Replies: 1124
Reply
RE: Calculating Corner by Coordinates

What am I missing? Sure, you could calc the resulting corners given that information.

3 months ago
Reply
RE: Trig Levelling... but more accurate?

I find it hard to believe it takes less time to set up these prisms than it takes to run levels. How many prisms am I going to need to do this? Do I h...

4 months ago
Reply
RE: Compass Rule on an "open" traverse

@ryn_lance That link has nothing related to a compass rule adjustment. Everyone should be wary of using anything this guy is proposing.

4 months ago
Reply
RE: Any tips or tricks on leveling the bubble on a rover rod?

@ryn_lance How in the world do you place your phone on the rod to determine if it is level? One of us is clueless but I'm not sure if it is me or you.

4 months ago
Reply
RE: Trimble R12 GPS GNSS Beidou Galileo RTK UHF

Anybody legitimately upgrading to an R980 wouldn't describe the R12 as having a built-in data collector. With the post screaming that it was written u...

4 months ago
Forum
Reply
RE: Trimble R12 GPS GNSS Beidou Galileo RTK UHF

Tell me more about this built in data collector. How do I enter my point codes and descriptions with the built in data collector?

4 months ago
Forum
Reply
RE: Trimble> SCS900 total station setup HI?

With an instrument height of 2.00' you might see an error of just over 0.02'. At an instrument height of five feet your slant measurement would be sli...

4 months ago
Reply
RE: Notes from the Virgin Islands

The average salary in the VI is $40,408. In Oregon it is $68,283. So just for perspective, he is making about $124,448 in Oregon wages. I think that s...

4 months ago
Reply
RE: P.O.B.

Just curious, how do you know where your parcel is if it is not tied to anything else?

4 months ago
Reply
RE: Earth Dam Surface Monitoring - GNSS

How much movement do you need to be able to detect?

4 months ago
Reply
RE: Leica snll121 carier dimensions

@john-putnam I didn't pay too much attention to the exact source but it was found with a google search.

4 months ago
Reply
RE: Leica snll121 carier dimensions

I printed it with my own pdf printer maybe this will work. I'm not sure how to send it otherwise. I'd email it if you post your email address. I'll al...

4 months ago
Reply
RE: Leica snll121 carier dimensions

Perhaps you can find your answer here in the attached pdf.  

4 months ago
Reply
RE: This listing for Trimble R980 is stolen

I asked the seller for the serial number. It is shown in the picture above if you would care to check for yourself to see if the unit is listed as sto...

4 months ago
Reply
RE: Why not Metric??

Kudos to the person who wrote the dosage instructions.

5 months ago
Reply
RE: Why not Metric??

is actually a very good reason not to do it again. Unless you have some new knowledge or there is evidence that the conditions have changed favorably,...

5 months ago
Reply
RE: Why not Metric??

The cost and disruption of the change itself will last for at least a generation. This is a very large negative. I don't see benefits that are valuabl...

5 months ago
Reply
RE: Summer learnings

Sounds like healthcare as Rube Goldberg would have imagined it.

5 months ago
Page 3 / 57