My grips are working with GRIPS variable set to "2". Sometimes things get changed somehow... Command: GRIPS, enter "2" Let me know if that helps. ...
Carlson software does this with .dwg files, with the option to browse a map to open drawings. If you have GIS software, it is not that difficult to k...
Carlson has a good page on hardware requirements.
Ole Man River, I can relate. Working full time, with a couple part time gigs, one kid still at home, and remodeling an old house. Had horses growing...
Steel tape (chain), plumb bob, and transit is as far back as I go.
Until it's right.... Seriously, though, I would have a hard time putting a number on the drafting time too. I find it varies greatly, but I do a lot...
@minbarwinkle You can buy a leather hammer holster that goes on a belt and has steel hinged jaws so you just slap the hammer into it instead of havi...
What Ozzy said. Run away from UCS!
I've eaten my share of crow. It's hydrogen sulfide gas that does the concrete in....
It wasn't driven plumb, so it was driven deeper to make the top closer to the correct coordinates 😉
The longer I do this, and the more I see threads like this one, the more I think that pincushions ought to be the first course or lesson of any survey...
Found one like that recently. Old iron pipe that agreed as well with the plat as anything in the subdivision that I could find, with two newer 1/2" r...
Sounds like a mighty mole. Guided by the start of the hole and operator's luck from what I've seen.
Found several really cool monuments. Axles, gigantic white oaks, old stone piles, old pipes. One of my favorites is a control point I set early on i...
I wanna learn from Murphy!
Welcome!
Chased a big FAT cow out of the road and back to the pasture one day, only to realize she was stopped at a cattle guard.?ÿ She made a move to try to g...
There's a dimple in a tack in a cap on a pin in a pipe.....
Your approach looks sound to me.?ÿ I'd say you've met the typical standard of care, and then some, with the results you've given above.
