Bill93, post: 420562, member: 87 wrote: I hope you filed the correct federal paperwork. There is serious trouble to be had when transferring unreport...

MightyMoe, post: 420421, member: 700 wrote: What he is doing (I think) is to use the elevation on a given bench mark for his ellipsoid height, he has ...

Some jurisdictions in Oregon are requiring 1 lot partition plats to consolidate legal lots. It all has to do with the national building codes and bui...

I would guess that the thermal expansion of the deep 3D type monuments is low given the fact that the majority of the rod is buried in earth. The gro...

My instrument (MS50) has several cameras built in. When using the telescope camera it can even include cross hairs.

Must be nice. Looking forward to another inch of rain tonight. Even for the NW this has been a wet year to survey. Now off to play in the mud in my...

Roger,If you are trying to determine your rod height you need to measure to the bottom of the prims mount (see attached diagram) and add 86mm. I thin...

Jim Frame, post: 419459, member: 10 wrote: Last week I did a 4-hour session on a First Order Class I mark for the GPSonBM program. I got a note back ...

Leave a CF card in the gun? I've never had this problem with one of our 1200's but then they all have a CF card as well as the one in the DC.

VA LS 2867, post: 419644, member: 1444 wrote: If using the orange glass hexagonal prism, only sight the faces of the prism with the yellow arrows for ...

Zoidberg, post: 419336, member: 8841 wrote: Just an FYI: I had a system go down with LDD05 on it. When re-installing to the new computer Autodesk info...

I used to use a chain tension scale coupled with a 24" breaker bar as a pro rod-man's torque wrench.

In this neck of the woods it is usually next to impossible to grant an easement to oneself, which is what you appear to be trying to do. I've worked ...

Junior/senior rights do not play into the interior of a platted subdivision. Subdivisions are by definition simultaneous conveyances and the assumpti...

FrancisH, post: 419219, member: 10211 wrote: Isn't the purpose of using published elevations from govt benchmarks is that you want your project elevat...

Squirltech, post: 419281, member: 11959 wrote: If you have C3D 2016, why do you still need LDD? :confused: Aside from the fact that I like some featu...

I just lost all LDD operation on my LDD 2009 after updating from C3D 2015 to 2016. Looks like I get to reload LDD for about the 300th time.

Dan B. Robison, post: 419036, member: 34 wrote: 16oz of brass with a hardened steel point...slid out of the sheath...tight in the fist...the 'veyor bo...

Mine still has the one that it came with on. Be it the one that it came with is not actually supposed to be permanent. It is grey and bubbly. I did...