@dmyhill I'm not sure that is totally correct.  In Washington you can legally digitally stamp a document if you go through the correct procedure...

Contrary to what some have posted about not carrying insurance.?ÿ Unless you are planning to work solely of private land owners whom are not accustom ...

@flga Workers compensation requirements for owners vary by state.  In Oregon the owners are not covered unless they specifically request to be.

My hero.

Ruan, I think the RH15 is a spread spectrum radio while the RH16/17 is long range blue tooth.?ÿ As for the CS15, some came with an RH15 compatible rad...

My experience has been that multiple constellations does help in post processed fast static.?ÿ Not all static is performed in clear open skies.?ÿ?ÿ

@a-harris The first major project I took on after going out on my own, in 1998, was mapping the  storm system at PDX.  This was back in the...

Back when LiDAR was a new thing it was all the rage to provide verification points for multiple ground covers.?ÿ Often I would be able to get a single...

For the most part I just export them from my CS20.?ÿ Sometimes I might use a text editor to clean it up a bit and add any need meta data.?ÿ I was able...

@dave-karoly If I've said it once I've said it 1000 times.  Friends should not let friends scale grid coordinates without truncating.

What did they say was discriminating??ÿ I'm going to guess 'rodman'

The other reason to keep the speed down is navigation. I'm usually looking at the DC to maintain good spacing between lines for proper grids.?ÿ

I've done quite a bit of mapping from a UTV.?ÿ Before RTK was introduced in the 90s it was done based on time and post processed. Now, for the most pa...

@rover83 Years ago, I think Geodometer or Trimble had a routine that you shot two points on the building's face and then turned an angle to the corne...

@shawn-billings Shawn, I was part of the original effort to establish LDPs in Oregon and am on the state committee working on the 2022 implementatio...

@mark-silver I use Geocke as my supplier for several deformation monitoring supplies.  They have some great stuff and are extremely easy to deal...

@eric-kara That is only 16Ah.  I'm not sure how long it would run the radio for

@adamw I might have to check that out.  Not that it matters on this job but I wonder about the rod height stability.

@bstrand No you just don't stop.  The proposal and subsequent contract state that I will perform a certain task.  If that task is not perfo...

@damien I'm not sure what size would work best for you.  Pacific crest should have some documentation on amp hour requirements at various output...