This is what we use all year. We are in the woods on boundaries 99% of the time, so the heat isn't so bad.They make one with a mesh back too.I need a ...
There you go Party Chef. Redacted. It's public record, but I will post on the safe side.
It's public record
In WV we set offsets. There is no point in tearing up a perfectly good road just for a corner that can be referenced just as easily with offset monume...
I charge what I charge because that is the price I need to be profitable. I don't care if another surveyor can do it for half price or twice the price...
sunrise 6:19 amSunset 8:25 pmI've been up since 2:15. I went and fell asleep about 10pm last night. Shouldn't have done that.
I bought an HP designjet 500 back in November of 2001. It is still going strong. Have had to change the belt a couple times. If HP is still putting ou...
voidintheabyss, post: 427162, member: 11972 wrote: If you know CAD, then how did you learn it?I started with r14 and was taught some of it by coworker...
MightyMoe, post: 424038, member: 700 wrote: Just curious,,,,,,,how did the boundary corners fit the contours,,,do you have elevations for them? No, w...
Thanks for all the input. I'm leaning against doing it. Just because of the liability of it all that has been pointed out several times on here. It do...
BK9196, post: 423979, member: 12217 wrote: I tend to be a bit cynical and apologize in advance, at first glance title block states, "PRESERVING THE PA...
dicker? Nope. Price is what I say it is. I posted my last one in the wrong thread.Had a client recently that wanted to dicker, that is after the job w...
On smaller stuff I give them a high and low estimate. But that is after doing preliminary research, such as having them send me a copy of their deed a...
MightyMoe, post: 423792, member: 700 wrote: I wouldn't do that, not unless they are my contours. On the location map ok; but not in detail on the boun...