2.3 miles with the UHF radios.?ÿ Put the base up as high as it will go and still be steady.?ÿ The only trouble I had was when the antennas were mis-ma...
@rover83?ÿ I think there are hazards that may arise while using CRTN.?ÿ In this particular case, I had measured those "external" control points using ...
@mightymoe?ÿ ?ÿI only did ONE localization.?ÿ That was after I set control simply using points observed while using CRTN.?ÿ I am guessing that CRTN us...
@lurker LOL?ÿ Thanks?ÿ?ÿ That is my grandson when he was very small.?ÿ?ÿ
@leegreen ?ÿ That's the thing,?ÿ I DIDN'T do a local transformation prior to resetting the control points. I'm thinking I should've done a "mock loc...
The S631 units are very good.?ÿ ?ÿI am having a minor issue with the IMU (tilt correction).?ÿ ?ÿ Field Genius is a very bulky software seemingly made ...
@gto234?ÿ ?ÿ I sent you a PVT message
@jaccen I am using Micro Survey Field Genius with the S631 units.?ÿ Still having a little IMU problem.?ÿ It may be Field Genius ??ÿ
After decades of working in the roads, I find the average driver doesn't look much farther ahead than 200 -300 feet.?ÿ I use bright cones,?ÿ ?ÿcouple ...
the brx7 is $3000 higher than the S631?ÿ Carlson has a put block on using their SurvCE for nonCarlson sponsored units?ÿ ?ÿi know nothing about stonex ...
You're not gonna believe this.?ÿ I discovered that my Iphone wifi and Bluetooth were on.?ÿ My Phone was connecting to the rover causing a disconnect f...
@plumb-bill?ÿ A hemisphere CW400?ÿ running windows mobile 6.5?ÿ I will change that to a Juniper Mesa ASAP?ÿ
@gto234?ÿ ?ÿ When I first got the receivers, IMU worked fine.?ÿ by the second job, troubles began and by the third and fourth job, I had to disable th...
@ladd-nelson.?ÿ Thank you.?ÿ I did a factory reset Via web. No improvement. In fact now the imu will not initialize at all.?ÿ After10 minutes, I disab...
Well, I bought field Genius.?ÿ Compared to Carlson Survce this is slow and difficult to navigate.?ÿ Also, this software doesn't allow a continuous con...
