For those of us up north, Rite in the Rain books stand up well not only to rain and snow, but also to the squishy biomass of mosquito/no-see-um/white ...
Probably a setting. Maybe "Vehicle Type" is set to this:
tomarneson, post: 433263, member: 864 wrote: All the auto levels that I used would rattle. Yep. A slight tap to the level and a corresponding jingle ...
aliquot, post: 432963, member: 2486 wrote: I make boundary decisions everyday. Yep. Not sure what they're doing back there in "Jawja" if they're not ...
Jawja, post: 432946, member: 12766 wrote: It is obvious from your opening comments that you really do not want a discussion on this, But rather want t...
Jules J., post: 432913, member: 444 wrote: GPS for bolt pattern to bore base plates? I would use a square, a pencil, and 2 pieces of cardboard. Measur...
thebionicman, post: 432911, member: 8136 wrote: With the equipment most of us have I would say no. Talk with one of the bridge guys about millimeter G...
Brad Ott, post: 431956, member: 197 wrote: No, but (detour warning) just yesterday my pastor told me about this short story by Leo Tolstoy:How much la...
Dave Lindell, post: 431751, member: 55 wrote: Geez, Kent. The guys wants one line. The lot has four sides. It should be one-fourth,. One-half, one...
Matt McCrory, post: 431685, member: 10684 wrote: I received an RFP email for surveying services, it included location monitoring wells and bore locati...
James Fleming, post: 431433, member: 136 wrote: Well yes, but that's mostly outweighed by the overarching disadvantage that the metric system is, of c...
When I was in Penn State's program, an attorney was a permanent member of the faculty. We had several classes where we were required to research case ...
Peter Lothian - MA ME, post: 431492, member: 4512 wrote: Low bid wins the public jobs in Mass. :tired_face: How is that possible? I assume most high...
Bill93, post: 431319, member: 87 wrote: So the surveyor becomes liable for correctly fixing the design omissions? Engineering without a license. Yep...
As someone else has said on this board: the standard for Construction Plans (and CAD work) used to be "Build-ready," now it's just "Approval-ready" or...
You might try marketing them out west. As another poster noted, we're pretty much reduced to softwoods out here. I'd have definitely paid a little mor...
Disappointing that this would somehow get a second lap (let alone a first) as a technical research paper. Would you say this is an outlier, or that pa...
Are we threatened by this because the public's going to be harmed? Haven't photogrammetry firms (often without an LS in responsible charge) been doing...