(5) Grinder with grinding bit. Got good deal ($10) on bit on Amazon. (4) Two-part epoxy. (3) Countersunk hole. (2) Centering template and hole dept...

I found out this morning, that they're azimuth points set near section corners for the purpose of tying in those corners to the SPC system.

@leegreen I don't know what version we have in the office. I just picked something from the Internet that appeared to be what I thought we had.

I agree, but my exported DL file wouldn't necessarily be for adjustment; I might use the file for another purpose. Maybe I want to print it out or arc...

I'm picturing the Parani SD1000 being strapped to a tripod leg with VELCRO?? brand, ONE-WRAP?? tape (levitthookandloop.com) and the wire connected to ...

@holy-cow Maybe, but they're not labeled as such. Please take a look at the right side of the plat.

I found a plat during my research that has something I've never seen before. Two points, designated GIS # 172 and GIS # 175, are tied to a section lin...

If deeds that predate those deeds as recorded on a property appraiser's website exist, how do I find them?

Some parts of it, yes; it's also curvilinear. The area I mentioned where there's a large discrepancy between calculated and measured distances is a tr...

Yes.

I'm starting some deed research. What is a special warranty deed, and how does it differ from a warranty deed?

Thanks to all for the abundance of information!

Welcome!

Heck of a name!

I enjoy the serenity of the woods.

Mine was a tad over a mile using a Topcon total station in 1988 during a large (2,400 acres) boundary survey near Indiantown, FL. Most of the distance...

@party-chef Sounds like what we used to do in the eighties in south Florida in new subdivisions where lot lines were only slightly staggered. We bent...