squowse, post: 433186, member: 7109 wrote: Sorry I haven't had much to do with external radios. Maybe you configure the frequency after you connect to...
squowse, post: 423552, member: 7109 wrote: no probsHi bud! i have a question regarding the setup between Trimmark 3 and my base R8s and my rover R10. ...
squowse, post: 423552, member: 7109 wrote: no probshow about for R8s?
hello, i've got a question. im using R8s and r10. but i've tried to use a trimmark 3. now my problem is i can't connect to my trimmark radio using TSC...
Pnw coast, post: 429853, member: 12522 wrote: I have had a lengthy conversation with a trimble tech about the vertical errors I've seen with the mt100...
squowse, post: 428681, member: 7109 wrote: Are you taping slope distance or horizontal distance? ;)Horizontal distance and even slope distance its the...
Hi guys. I have a question. Today i setup my Trimble S6. I tried the MT1000 setup on a tribrach. I take measurements both passive and active mode but ...
Hey guys! my problem is solved. Mr. Geoff Geigling fixed my problem. reliable service tech.
squowse, post: 424472, member: 7109 wrote: I think your instrument is now without firmware unfortunately so will not accept an update. Hope it doesn't...
squowse, post: 424305, member: 7109 wrote: How did it happen? Maybe your advice might save someone else the same problem?it was updating when the brea...
it was updating when the breaker went off. i restart the laptop and re-start the firmware update. this time the firmware update tool can detect the in...
Geoff giegling, post: 424047, member: 12666 wrote: That's too far, in the US. Suggest that you send it to a reputable dealer. They will need to try to...
thank you for the information. maybe thats the only way i can do at this time...
Geoff giegling, post: 424044, member: 12666 wrote: Not sure where your instrument is located, but we can take care of it for you. at geotx.comIm here...
Im here now in the Philippines.
squowse, post: 424031, member: 7109 wrote: are you following this procedure?
squowse, post: 424031, member: 7109 wrote: are you following this procedure?
Jim Connelley, post: 423976, member: 12008 wrote: Some will have a pinhole reset. Poke it with a paper clip.this is about a firmware issues. im not ...
this is about a firmware issues. im not sure if there is a pinhole reset for this.
latest update... i restore may laptop before the interrupted firmware update... now the device is being detected as ARM7 satellite. but still it doesn...